This site uses cookies. By continuing to use this site you are agreeing to our use of cookies.

BHCI Series Aluminum Sill-Height Convection Heater

The sleek, flowing curved aluminum front cover and end caps of the BCHI offer a unique design for architectural applications. They are designed to fit under large windows to prevent cold down drafts. These heaters can provide total or supplemental heating for a variety of applications. The rugged design is built to withstand years of hard usage for your commercial application.

  • Easy to Install: Units may be mounted flush to the wall or directly to any floor surface. There are no screws on the front cover. Two rows of mounting holes on the back of the heater are spaced at 2 inch (51 mm) intervals for easy mounting. An electrical junction box is provided at each end of the unit for easy connection to the power wiring. To remove the cover, locate the locking tab at the bottom center of the heater. Rotate the tab counterclockwise with a tool through the air inlet and the cover can be withdrawn.

  • Choice of colors: Heaters can be matched to any decor. White or metallic charcoal are standard and a wide range of optional colors and custom finishes are available (see optional color selections on inside back cover).

Standard Construction Features

Heating elements

Stainless steel elements with tight fitting aluminum fins float on high temperature nylon bushings for quiet and efficient operation.

Housing

Cabinet is constructed of 20-gauge galvanized steel with a robust aluminum front cover. The unit has an epoxy/polyester powder paint with a satin finish in white or metallic charcoal.

Inlet/Outlet Grilles

The fresh air inlet grille is located at the bottom of the front of the unit. The outlet is located at the top with openings less than 0.25” to discourage tampering with the heating element (pencil-proof).

Built-in Controls

Linear limit, automatic reset thermal cutout.

Electrical Connection

Each baseboard heater has a junction box located on both ends and a built-in full length wire way.

Installation Requirements

Field or factory-installed low voltage relay and thermostat kits fit into the right-hand junction box only.

Factory Built-in Options

  • Disconnect Switch
  • High Altitude Automatic Cutout
  • Relay
  • Relay with Transformer
  • TRIAC Proportional Relay
  • TRIAC Proportional Relay with Transformer
  • Tamperproof Thermostat
    • Single-pole
    • Double-pole
  • Adjustable Thermostat
    • Single-pole
    • Double-pole

Field-Installed Options

Shipped loose for field installation into heater

  • Disconnect Switch
  • Relay Kit
  • Relay Kit with Transformer
  • TRIAC Proportional Relay
  • TRIAC Proportional Relay with Transformer
  • Tamperproof Thermostat Kit
    • Single-pole
    • Double-pole
  • Thermostat Kit
    • Single-pole
    • Double-pole
  • Remote Wall Mount Thermostat
    • Line Voltage
    • Low Voltage
secret