This site uses cookies. By continuing to use this site you are agreeing to our use of cookies.

WRI Series Register Wall Heater

The WRI register wall heater is ideal for use as a primary heat source in small areas or as supplemental heat in more spacious areas. Multiple heaters can be used to effectively heat large or odd-shaped rooms.

  • Installation Options: Units are designed for recessed mounting into shallow 2-inch by 3-inch stud walls or surface mounting with the use of an optional box.

  • Safety: Finned tubular elements provide electrical isolation from accidental contact.

  • Temperature Control: An optional thermostat can be installed in the heater or a remote thermostat can be used.

Standard Construction Features

Heating Elements

Steel finned tubular elements.

Outlet Grille

The louvered front grille is made from 20-gauge steel. The grille is finished with an epoxy/polyester powder paint in white or almond.

Built-in Controls

Automatic reset thermal cutout and overtemperature warning light.

Fan Motor

Quiet, factory lubricated fan operates at 38 dBA at 40 CFM for models up to 1,000 W and 41.3 dBA at 80 CFM for all models rated above 1,000 W.

Installation Requirements

The air outlet should be installed a minimum of ten inches above vinyl floors.

Rough In Dimensions

All heaters: 14-1/8" wide x 7-3/16" high x 3" deep.

Factory Built-in Options

  • Disconnect Switch, Double-pole
  • Thermostat
    • Single-pole
    • Double-pole
    • Tamperproof
    • Off position

Field-Installed Options

Shipped loose for field installation into heater.

  • Surface Mounting Box
  • Thermostat Kit
    • Adjustable
    • Tamperproof
    • Single-pole
    • Double-pole

Thermostat

Remote Wall Mount Thermostat Available

  • Line Voltage
secret